Sorry Chol can update me? have you finished debugging? Thanks

  • chol replied to this.

    Satellitare
    We are done debug. The data from the tracker received normally. Check it.

    Yes tracker send data normally, but device its always offline.

    Issue its with new orange device its always offline.
    With old orange tk8800 and other kingneed see online normally.

    I have ask if you can fix this

    • chol replied to this.

      Satellitare
      Legacy mode only offline. It works only to receive data from the old hardware gateway. Does not support commands.

      23 days later

      Hello, I joined the Kingneed T12SE and immediately all the functions worked perfectly. Next, I connected the T8800 and is seen online, sending data, but I do not see the position on the map. Could you give me an advice please ? ID: 864768010730965. Thank you very much

      • chol replied to this.

        In the tracker, of course, I set it to routetrack 99-means always on. Please advise, thank you

        The GPS WOX normally sends me data and location with the same settings I have for GPS Trace.

        a month later

        I am following this post. I have a Kingsneed TK20C. What settings do I need to use to pair that unit to this website?

        • chol replied to this.
          2 months later

          Hello. I finally took the time to setup my TK20C tracker. What I found out is that I can see actual movement of the tracker but unable to view any history. Nothing there. Have I set this unit up incorrectly during setup? Why I can see real time movement but no history?

          • ashe replied to this.

            I have a Kingneed TK20C tracker. I have reset the unit and entered in all of the IP and PORT data (setip19319316516621766*). The unit is set as a Legacy using a Kingneed TK20 setting on GPS-Trace. I have entered the TK20C IMEI number (015136000624549). I can see the unit position on the map, which is correct location, on the GPS-Trace website. But the website does not show any data. Just states it is offline. What am I doing wrong?

            • ashe replied to this.

              SteveEdgar Hello!
              Please configure your tracker on the following server and port for debugging: server 193.193.165.37 port 22785
              Write to us when you do this.

              6 days later

              Finally got a response from Kingneed. To program an IP Address and Port Number, they say to use this command:

              Lets say we are going to set the IP to 193.193.165.37, Port 22785.

              <asterisk>setip<asterisk>193.193.165.37<asterisk>22785<asterisk>

              Please replace <asterisk> with the *
              This is what they say is the proper command.

              Hello Ashe. Reprogrammed the unit to server 193.193.165.37 port 22785. Can you see it?

              • ashe replied to this.

                SteveEdgar Hello!
                We have received your letter, we are glad that at the moment your tracker has successfully connected.
                Or do you write about another tracker on the forum?