I have a Sinotrack ST-901A+
I did a search in the forum and tried to configure it with the ports: 32329 and 20490 with no results.
The saller on aliexpress linked me to a discussion on traccar forum where the protocol seems to be used is huabao
which port should i use to make it work in gpstrace?
You can try the types of trackers Gosafe G91I or Rilla G19
At the same time, we don’t have a protocol for this tracker, and we can’t say for sure whether it will work.
After changing the settings, you can go to the Toolbox (unit menu - Tools - Toolbox), where in the log section you can see if your tracker is connected and if errors occur after that.
I have tried both protocols.
which are respectively:
Gosafe G91I - 20490
Rilla G19 - 20275
I set up sending on the test server to extract the ID, but for both protocols I don’t see anything.
I have set up my dashboard for both, but when I try to see the messages it gives me an error and does not show me the logs.
how can I do?
Can you see the data in the Toolbox now?
tambe. estou tentado e nao consiigo esse modelo e novo ST901+A tenho o protocolo como faço para voce incluir?
Flavio tambe. estou tentado e nao consiigo esse modelo e novo ST901+A tenho o protocolo como faço para voce incluir?
try to use their platform for now (sinotracker), waiting for the gpstrace to implement the protocol (which I proceeded to send to the support team).
A little update:
I confirm the fact that st-901a+ uses a protocol called “huabao”, the same protocol is also used by Gosafe G1C.
In Wialon, the Gosafe G1C use the port 21686, but in GpsTrace I can’t find the G1C.
G1C is necessarily needed because it is the only one in the Gosafe family that uses a different protocol.
We added the protocol Device Category - Legacy, Device Type - Gosafe G1C, you can try to configure the unit and tracker.
Write to us about the results please.
For this type of device, the ID is as follows:
0 + ID written on the lid.
Now it seems to work, but in my case I still don’t see the position: I don’t know if it’s a problem with my device or your decoder.
Thanks for the support, keep us updated! 😃
You can look in the Toolbox if there is data on latitude, longitude and altitude. You can also send us a screenshot of Toolbox and main screen where unit is online and without position.
Ok! It works as Gosafe G1C!