Hi I have a Sinotrack ST-901A+ I did a search in the forum and tried to configure it with the ports: 32329 and 20490 with no results. The saller on aliexpress linked me to a discussion on traccar forum where the protocol seems to be used is huabao which port should i use to make it work in gpstrace?

AndreaEsposito Hello! You can try the types of trackers Gosafe G91I or Rilla G19 At the same time, we don’t have a protocol for this tracker, and we can’t say for sure whether it will work. After changing the settings, you can go to the Toolbox (unit menu - Tools - Toolbox), where in the log section you can see if your tracker is connected and if errors occur after that.

I have tried both protocols. which are respectively: Gosafe G91I - 20490 Rilla G19 - 20275 I set up sending on the test server to extract the ID, but for both protocols I don’t see anything. I have set up my dashboard for both, but when I try to see the messages it gives me an error and does not show me the logs. how can I do?

AndreaEsposito Hello! Can you see the data in the Toolbox now?

tambe. estou tentado e nao consiigo esse modelo e novo ST901+A tenho o protocolo como faço para voce incluir?

Flavio tambe. estou tentado e nao consiigo esse modelo e novo ST901+A tenho o protocolo como faço para voce incluir? you can’t try to use their platform for now (sinotracker), waiting for the gpstrace to implement the protocol (which I proceeded to send to the support team).

A little update: I confirm the fact that st-901a+ uses a protocol called “huabao”, the same protocol is also used by Gosafe G1C. In Wialon, the Gosafe G1C use the port 21686, but in GpsTrace I can’t find the G1C. G1C is necessarily needed because it is the only one in the Gosafe family that uses a different protocol. fingers crossed!

AndreaEsposito Hello! We added the protocol Device Category - Legacy, Device Type - Gosafe G1C, you can try to configure the unit and tracker. Write to us about the results please.

For this type of device, the ID is as follows: 0 + ID written on the lid. Now it seems to work, but in my case I still don’t see the position: I don’t know if it’s a problem with my device or your decoder. Thanks for the support, keep us updated! 😃

AndreaEsposito Hello! You can look in the Toolbox if there is data on latitude, longitude and altitude. You can also send us a screenshot of Toolbox and main screen where unit is online and without position.

Ok! It works as Gosafe G1C! Thanks!

ST-901A+ port?

dapi

MwangiNderitu Hello.
Please note that our forum is intended for problem solving of the users of GPS-Trace application.
If you are asking for the commands to send for your tracker configuration please see the instruction for your tracker because commands for different tracker models can vary greatly.

Name

Good afternoon! Please tell me if there are SMS commands to reboot the tracker? The situation is that the tracker is stuck in one coordinate, although the car is actually moving.
Sincerely, Name!

rost

Hello Name ,

Try to use RESET# command.

« Previous Page