i have bought Concox JM-LL01 tracker and have trouble configure it and I don’t have all available commands and explanations. Could you help me? Can you provide me full list of commands with explanations?

Furthermore, i have few questions if you can help me:

  1. I set the mode,1,60,360# so that it sends the position every 60 seconds, but when it starts, it reports every few seconds? Vibration senalm is off.

  2. What this commands does and how to use it:
    staticrep#
    sensor#
    timer#

  3. How can you listen to the environment around the tracker? Is it possible to configure it through bluetooth or/and with AT commands?

Thank you.

  • rost replied to this.

    Hello Parsley

    Sorry, we don’t have GPRS commands for this device. That is, technically this functionality will work, but we do not know the command syntax itself.
    We only have an example payload (syntax) of the command:
    f.e. command to Cut OFF petrol:
    {“payload”:“RELAY,1#”}

    For command syntax, we recommend that you contact the manufacturer directly. They will be able to provide you with the information you need. Also, if you receive this information, we will be glad if you share it on our forum.

    Now for your questions:

    1. This question can only be answered by the manufacturer. Most likely it is in the firmware, or in some additional setting. From our side, we only receive data, calculate it and display it.

    2. From this list, only the timer# command is familiar to us.
      We could not find the rest of the commands either in the official manuals or anywhere else.
      Info about staticrep# command you can find here by the link. https://pdfcoffee.com/concox-gps-tracker-ob22commandsv10-pdf-free.html
      Also there you will find a timer# command explanation.


      Unfortunately we didn’t find any info about sensor# command.

    3. In this case you can listen the environment only via call to the tracker(to SIM card). If this tracker supports such function(have a mic and software for this inside).


    If you have any additional questions about the application or you will find information, just write there.

    In attachment is commands used by JM-LL01, but I think that’s not all. I still need monitor, call, command and
    possible bluetooth communications and AT command.

    ll01commandlist-v14-20220414-copy.xlsx
    37kB