• NewsAnnouncement

  • Ruhavik 1.6.0: extended menu, custom commands and a little more:)

The “monitor123456″ command serves to enable the device’s microphone function. After use, it is necessary to send the “tracker123456” command for the tracker to work again on the plataform, sending the locations.

  • rost replied to this.

    Hello, AndreLuiz ,

    For premium users, the creation of a custom TCP command available.
    You can write commands yourself. The syntax for such a command will need to be checked with the hardware manufacturer.


    Also, if possible, ask the manufacturer for the protocol where such a command will be indicated. Also check the possibility of its execution by TСP, perhaps this command will not be able to be executed by TСP.

      11 days later

      ashe hi i have gt06 tk100 accurate gps tracker

      • ashe replied to this.

          ashe for example cut123456 and resume123456 i would lile to know how to create string is cut123456 a string?

            Natalino Hello!
            Such a manufacturer is not directly integrated with us and we have no documentation for it.
            What models did you indicate for the devices of this manufacturer in the application?

              a month later
              ashe unstickied the discussion .
              6 months later

              hi all. pity what gprs command not work. its good and fust srvice for reboot device etc.
              so i have try with my cargo ligth cl2 but not sucess (
              manufacturer write instruction for gps coordinates (dog)info:gps(dog)
              but result - error execute command

              and without (dog) -error.
              wendor tell recomendation of send commasnd

              • "При настройке через GPRS посредством вашего сервера пароль не требуется, но
                требуется поддержка протокола “CarGo Data Protocol” и обрамление командного
                слова знаками(знак собаки), в начале и в конце."
              • rost replied to this.

                Hello, DimoNET .

                Please write us to support@gps-trace.com we need to check this issue additionally.
                We are well acquainted with this manufacturer and will be able to solve this problem. Most likely the syntax of the command is incorrect.

                We also recommend that you first contact the manufacturer with this question, they will most likely help you quickly. They are very familiar with our application and the integration of their devices took place with their full participation.

                Thank you for contacting, we will wait for a letter from you, but once again we advise you to write to the manufacturer, so most likely the problem will be solved faster.

                  3 months later
                  1. What command to set in the command panel on Android Aplication if I use teltonika fmb140 and I want to change the digital output 1 (DOUT1) status to active for e.g. 1h.
                  2. What command to set in the command panel on Android aplication if I use teltonik fmb140 and want to change digital output to permanently deactivated?

                  In both cases I mean quick commands without going into Setbox settings

                  • kula replied to this.

                    Hello, dear ArturArtur

                    The syntax of commands should be checked with the hardware manufacturer, which has the appropriate documentation.

                    If you have any additional questions, do not hesitate to write to us, we are always happy to help.