Hi everyone,
Remote device configuration its not available for selected device Concox GV40.
Please, make availible.
thanks in advance
Best regards
Nicolai

  • rost replied to this.

    Hello, pataya2112

    Specify what commands you would like to see in the Setbox for this type of device?

        rost

        everything that’s possible, like GPRS Time Interval Setting, Center Number Setting, Factory Setting etc.

        • rost replied to this.
            2 months later

            pataya2112 Hello,

            The question was postponed a little due to the workload of the developers. We are sorry for the delay.

            Now, in order to start finalizing the commands for this type of device, we need:
            1) So that you direct your device to server 193.193.165.37 and port 25591.
            2) Please write a specific list of required commands. It is not possible to add everything, so if you formulate the list of required commands precisely, it will speed up the process.
            3) If possible, send the documentation for this device.

            Thank you in advance!

              Hello, pataya2112,

              Thanks for the info.
              We have received the information and will notify you when the revision is done.
              We plan that new commands for the device will appear around the end of the week. Please wait.

                Hello again, pataya2112 ,

                Can you please point and activate your device to 193.193.165.37 and port 25591 again?
                Now it’s inactive and we can’t check it.

                Please activate the device and keep it active for a few days. Thanks in advance!

                  Hello, pataya2112 ,

                  We have added all the commands for the Concox GV40 to the Setbox.
                  Please check from your side.
                  Also, please email us about the results.