GMT100 integration

FidelEduardoLpezMayorga

I would like to know if there’s a way to control the output relay in the Queclink GMT100 & GMT100N?? I don’t find any option in the Toolbox to send a command to the tracker. Any help is appreciated. Thanks!

ashe

FidelEduardoLpezMayorga Hello!
Could you clarify which commands from the trackers available you would like to send from the application, commands to block / unblock the engine or some others?

FidelEduardoLpezMayorga

ashe It’s the AT+GTOUT command… The tracker has one internal CUT relay.

So I think this is the command for disabling the relay:
AT+GTOUT=[password],0,0,0,0,,,,,,,,,,[serial no.]$

And this one for enabling it:
AT+GTOUT=[password],0,0,0,1,,,,,,,,,,[serial no.]$

Ideally would be used for enabling / disabling the engine or fuel pump..

You could also check page 21 on following link:
https://www.eddywireless.com/yahoo_site_admin/assets/docs/GMT100_Track_Air_Interface_Protocol_V105_decrypted.99183956.pdf

ashe

FidelEduardoLpezMayorga Hello!
Would you like these commands to appear for indicated models in the unit menu - Tools - Setbox or would you also like them to appear as buttons on the unit card?

FidelEduardoLpezMayorga

ashe On the unit card would be awesome.. Thanks!

ashe

FidelEduardoLpezMayorga Hello!
We will consider the possibility of adding these commands for these tracker models.

ashe

FidelEduardoLpezMayorga Hello!
At the moment, the commands you specified have been added to the Setbox.

You can try to use them.
In the future, we will consider the possibility of adding them as buttons on the unit card.

FidelEduardoLpezMayorga

ashe Cool, will take a look on the commands and report back!! Thank you!!

ashe

FidelEduardoLpezMayorga Hello!
We will be waiting for your feedback to make sure that the new commands in the Setbox work well.